Custom Bathrooms

Bathroom Renovations in Edmonton

A bathroom is the hardest working room in the house and the least forgiving of shortcuts. Bespoke Contracting builds Edmonton bathrooms that are waterproofed properly, tiled cleanly, and finished to last, from compact powder rooms to full ensuite retreats.

Design + BuildFixed ScopeLicensed TradesFree Consultation
Design + Build In House
Fixed Written Scope
Licensed Trades
Edmonton + Capital Region
Warranty Backed
The Situation

The bathroom is where cut corners come back

A bathroom renovation in Edmonton lives or dies on what you cannot see: the waterproofing behind the tile and under the floor. Get that right and everything else is finish work that shows beautifully. Get it wrong and no amount of expensive tile will save you from tearing it out in five years when the wall behind the shower has quietly rotted.

More than any other room in a home, bathrooms punish poor workmanship, and they do it out of sight. A shower that was not waterproofed correctly does not fail dramatically. It weeps water into the wall cavity month after month until the framing is soft and the drywall behind the tile is black. Tile set on the wrong substrate cracks along the grout lines and lets water through to start the same slow process underneath.

This is why we treat the hidden layers, the waterproofing membrane, the slope of the shower floor, the backer board, the sealed penetrations, as the real project. The tile you pick is the part you see and enjoy, but the part that decides whether your renovation lasts ten years or two is buried behind it. A bathroom done right is invisible where it counts.

Older Edmonton bathrooms frequently reveal the cost of previous shortcuts. When we strip an old bathroom back and find rot or mould from a shower that leaked for years, we show you, deal with it properly, and then build the new bathroom the way it should have been built the first time.

Our Approach

How we work

Built from the waterproofing out

Our sequence in a bathroom is deliberate and it does not change to save time. We strip to the studs and subfloor so we can see and correct anything hidden. We build up proper waterproofing and, in a shower, the correct slope to the drain, using a membrane system rather than relying on water resistant board to do a job it was never designed to do. Only once that envelope is sound does a single tile go on.

From there it becomes finish work, and finish work is where craft shows. Tile set clean and level with consistent grout lines and cuts that land where they should. A vanity scribed to a wall that is not straight. Glass, lighting, and hardware that pull the room together. A small bathroom leaves nowhere to hide a sloppy line, which is exactly why the precision matters so much in the one room where every surface is at arm's length.

How It Works

Our Process

01

Design and selections

Layout, fixtures, tile, and vanity chosen against a fixed scope so there are no surprises, and so you can picture the finished room before demolition begins.

02

Demolition and waterproofing

We strip to the studs and subfloor, correct anything hidden, then build up proper waterproofing and slope. This is the stage that decides how long your bathroom lasts, so it is the stage we never rush.

03

Tile and fixtures

Tile is set clean and level on a sound substrate, followed by the tub or shower, vanity, toilet, and fixtures, each installed by the right trade.

04

Finishing and detailing

Lighting, mirrors, glass, hardware, paint, and the small adjustments that make the room feel considered, all walked with you at the end.

What We Do

What a bathroom renovation can include

Showers and tubs

Custom tiled showers, freestanding and drop in tubs, and glass, all built on proper waterproofing and correct slope so water goes where it should.

Tile and waterproofing

Membrane, backer, and tile installed in the right order, with sealed penetrations, so water stays out of the wall and floor for good.

Heated floors

In floor electric heat under tile, a modest upgrade that transforms an Edmonton bathroom through a long winter and is far easier to add during a renovation than after.

Vanities and storage

Custom and stock vanities, medicine and linen storage, and cabinetry scribed to fit rooms that are rarely perfectly square.

Plumbing and fixtures

Licensed rough in and finish plumbing for tubs, showers, sinks, and toilets, coordinated with the tile and cabinetry.

Lighting and electrical

Proper vanity and ambient lighting, exhaust sized for the room, and GFCI protected circuits, all to code.

The Bespoke Standard

The part you never see is the part we obsess over.

Beautiful finishes are only half the job. What sits behind them, done properly, is why our work is still sound in ten years.

Getting It Right

What sets the work apart

Why our bathrooms last

The single most important thing we can tell you about a bathroom is that waterproofing is not optional and it is not where you save money. We build the hidden layers to standard every single time, because that is precisely the part that fails when someone rushes it, and it fails expensively, taking the framing and finishes with it. A properly waterproofed bathroom is one you never have to think about again.

Above the waterproofing, tile is where the craft becomes visible. Straight lines, tight and even grout, cuts that land cleanly at edges and corners, and layouts planned so you are not left with a sliver of tile in the most visible spot. In a room this small, every surface is seen up close and every imperfection is obvious, which is exactly why precise tile work is worth insisting on.

What shapes a bathroom budget

Bathroom costs are driven by size, the complexity of the tile and shower, whether plumbing moves, and the fixtures you choose. A powder room with a sink and toilet is a modest project. A full ensuite with a custom tiled shower, a freestanding tub, heated floors, and relocated plumbing sits at the other end of the scale entirely.

Custom tiled showers and intricate tile patterns take skilled labour and time, which is where a lot of a bathroom budget goes, and it is money well spent because it is the part most likely to fail if done cheaply. Custom glass and certain tile carry lead times that we plan for so the finish stage is not held up.

You get a fixed written price against a defined scope after design, so you can weigh a heated floor or an upgraded shower against real numbers rather than discovering the cost after you are committed.

Worth Knowing

The details that matter

Waterproofing is the whole job

The difference between a bathroom that lasts twenty years and one that fails in three is almost entirely invisible once the tile is on. It is the waterproofing behind it. A bathroom is the wettest room in the house, and water is relentless about finding any gap in the system. We build the wet areas to a proper waterproofing standard: the right membrane, correctly lapped and sealed, sloped where it needs to drain, tested before a single tile goes up.

This is exactly the kind of hidden work that a cheap renovation skips because no one can see it, and it is exactly the kind of failure we get called to fix later. When water gets behind a poorly built shower, it does not stay in the shower. It travels into framing, subfloor, and the ceiling below, and what started as a bathroom problem becomes a structural one. Doing the waterproofing right the first time is the least glamorous and most important thing we do in a bathroom.

Layout, accessibility, and the details

Small bathrooms punish bad layout decisions. A few inches in the wrong place makes a door swing awkward, a vanity crowd a toilet, or a shower feel like a phone booth. We plan the layout around how the room is actually used, and we are candid about what is possible within your existing plumbing and what would require moving it. Sometimes the best value is a smarter layout within the same footprint rather than an expensive reconfiguration.

We also build with the future in mind where it makes sense. Blocking in the walls for future grab bars, curbless shower entries, comfort height fixtures, and slip resistant flooring are small decisions during a renovation that pay off enormously if mobility ever becomes a concern. Whether the bathroom is a busy family space or a spa like retreat, the goal is the same: a room that is beautiful, genuinely functional, and built to stay that way.

Why Bespoke

Why our bathrooms stand out

Waterproofing is never optional

We build the hidden layers to standard every time, because that is the part that fails when someone rushes it, and it fails expensively.

Clean, precise tile

Straight lines, tight grout, and cuts that land where they should. In a small room every surface is at arm's length and craft is impossible to hide.

Coordinated trades

Plumbing, electrical, tile, and finish carpentry all managed by one team against one scope, in the right order.

Built to last a decade

We treat the substrate, slope, and membrane as the real project, so the beautiful part on top has something sound to sit on.

Common Questions

Frequently Asked Questions

How much does a bathroom renovation cost in Edmonton?+
A powder room is a modest project, while a full ensuite with a custom tiled shower, heated floor, freestanding tub, and moved plumbing sits much higher. After design we give you a fixed written price against a defined scope so you can decide with real numbers and weigh the upgrades that matter to you.
How long does a bathroom renovation take?+
Most bathrooms run a few weeks depending on tile complexity and whether plumbing moves. Custom glass and certain tile lead times can extend the finish stage, which we plan for up front so the project does not stall waiting on materials.
Do you install heated floors?+
Yes. In floor electric heat under tile is one of the most popular upgrades we do in Edmonton, and for good reason through our winters. It is far easier and cheaper to add during a renovation than to retrofit later, so a bathroom reno is the time to decide.
How do you waterproof a shower properly?+
We build the shower with a correctly sloped substrate and a waterproofing membrane system behind and under the tile, with sealed penetrations, rather than relying on water resistant board alone. It is the difference between a shower that lasts and one that slowly rots the wall behind it.
Can you work with a small or awkward bathroom?+
Yes. Older Edmonton homes are full of tight, oddly shaped bathrooms, and that is exactly where a design build approach and custom cabinetry earn their keep. A smart layout and a scribed vanity can make a small bathroom work far better than its size suggests.
Can you convert a tub into a walk in shower?+
In most cases yes. Converting a tub to a walk in or curbless shower is a common request, especially for aging in place. It involves reworking the plumbing and rebuilding the waterproofing and floor, all of which we handle.
Do you handle the design and tile selection?+
Yes. We guide you through layout, tile, fixtures, and vanity selections so they work together and suit your budget, and so you can see the finished room before we begin.
What if there is already water damage or mould behind the old shower?+
It is common, because a failing shower can leak unnoticed for years. When we open an old bathroom and find rot or mould, we show you, and if remediation is needed we bring in a qualified restoration specialist to make it safe before we rebuild. Then we build the new bathroom the way it should have been done the first time.

Let us build your bathroom renovation

Tell us about your project and we will walk you through what it takes to do it properly.